Stainless Steel Portable Pressure Steam Sterilizer Instructions

1, water plus water in the autoclave steam sterilizer to the above heating pipes (about 3 liters), continuous use must be added above the water.

2, seal: would require sterilization of items evenly scattered and orderly placed in sterilized bucket and then sterilized bucket into the sterilizer, and the cover lid, put the hose into the steam sterilization barrel Galteli inside. After the alignment of the upper and lower groove, symmetrical wingnut tightened to seal the requirements (use if the situation continues to leak tighten the nut can be removed).

3, heating: After ohmic heating, take the child on the first release valve deflated vertical position, so that the cold air sterilizer overflow, when steam emitted when the bleed valve then take the child reset. When the pressure reaches the desired range sterilization, sterilization start time is calculated according to a different article.

4, drying: After instruments, dressings, utensils and other disinfection required when dry, can be disinfected after the end of the steam sterilizer release valve to drain. When the gauge is reset to zero for 1-2 minutes. Then open the lid and continue heating 10min to achieve the purpose of drying.

Note:

1, note that the water level before each sterilization to avoid damage to heating pipes empty beaker.

2, different items should be classified sterilization.

3, always check the pressure gauge when the gauge pointer is not reset, the reading should be allowed to cut off the heat, promptly repair or replace the pressure gauge.

4, when the dry heat sterilizer work, the staff do not leave the scene.

More info, please visit: www.sadalimited.com